![]() 254 | 7 | 0 alone would Not be complete yet and 255 | 0 | 0 would indicate the basic settings was interrupted or failed.The live data should display 254 | 0 | 0 to confirm a successful Basic Settings after 3 -to- 6 minutes.Do not exit or abort the Basic Settings sequence prematurely if you hear clacking noises. It is normal for the transmission to make noise while the tolerances are adapting.If 4 | 0 | 0 is not shown do NOT start the engine, something is wrong with the procedure or the transmission. After the 4 | 0 | 0 results are displayed, start the engine immediately and allow it to idle.The live data should display 4 | 0 | 0 in Basic Settings.NOTE: Be sure to perform the following steps in the sequence shown, followed by the defined test drive. See the Special Notes if the Mechatronic unit needs to be replaced.Brake Pedal operated (hold for the whole procedure).The Measuring Block value for G510 is found in group 011.1 No Fault Codes (other than No/Incorrect Basic Settings stored in the TCM).When replacing this Mechatronic unit, simply copy the coding from the original Auto-Scan and paste it into the New Coding section of the replacement followed by clicking.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |